87AzRunner's Photobucket Diff Breathers album media

Rear Diff Breather Ext.

87AzRunner — Fri, 2 May 2008 00:55:03 MDT

87AzRunner posted a photo

Rear Diff Breather Ext. - IMG_2416.jpg

Just took out old breather, cleaned it, pulled the cap off. Bought 3ft of clear vinyl tubing from ace for 49 cts a ft. and hose clamped it to breather. We'll see how vinyl last, pretty sure it will harden an crack, but who knows. Slack in place for flex btw. (Runs straight up into floor mounted tool box incase you were wondering.)

Rear Diff Breather Ext. end point

87AzRunner — Fri, 2 May 2008 00:54:43 MDT

87AzRunner posted a photo

Rear Diff Breather Ext. end point - IMG_2419.jpg

Comes straight up into a floor mounted tool box, can breather without a filter because it's protected from the elements.

Front Diff Breather Ext. end point in underhood fuse box

87AzRunner — Fri, 2 May 2008 00:54:27 MDT

87AzRunner posted a photo

Front Diff Breather Ext. end point in underhood fuse box - editthree.jpg

I had it inside the under hood fuse box because it is the most straight up route, the breather is protechted from the elements (such as water splashing into the engine bay) inside the fuxe box because it has a lid. don't have to worry about heat hurting fuses unless in 4wd because the front diff isn't engaged making the gear oil hot unless in 4wd drive.

Front Diff Breather Ext. Comes up and tied to engine mount

87AzRunner — Fri, 2 May 2008 00:54:25 MDT

87AzRunner posted a photo

Front Diff Breather Ext. Comes up and tied to engine mount - edittwo.jpg

left some slack in case body twist on frame a little bit, but not to much cause with ifs the front diff doesn't move up and down or side to side like a SFA does.

Front Diff Breather Ext. Starting point

87AzRunner — Fri, 2 May 2008 00:54:23 MDT

87AzRunner posted a photo

Front Diff Breather Ext. Starting point - edit.jpg

Again just cleaned the stock breather, pulled the metal cap of and hose clamped the tubing from ace hardware onto it. The Breather tube is ziptied to the engine mount to keep it from touching the oil pan and melting, but there is some slack between the engine mount and ending location incase the body flexes a little. (don't want the line to be pulled of breather piece, then what's the point of an extension? haha.)