87AzRunner's Photobucket Fj Top album media

untitled.jpg

87AzRunner — Wed, 9 Jul 2008 23:54:41 MDT

87AzRunner posted a photo

untitled.jpg

Rear-view of top

87AzRunner — Sun, 11 May 2008 10:20:08 MDT

87AzRunner posted a photo

Rear-view of top - IMG_2502.jpg

Bow mounting

87AzRunner — Sun, 11 May 2008 10:01:31 MDT

87AzRunner posted a photo

Bow mounting - IMG_2490.jpg

bolts into rollbar and slides into square at the bottom so it wont move at all.

Tension clip

87AzRunner — Sun, 11 May 2008 10:01:20 MDT

87AzRunner posted a photo

Tension clip - IMG_2496.jpg

had to cut and re-sew it up higher, just hand sewed, so far has held up for a year.

Tension clip

87AzRunner — Sun, 11 May 2008 10:01:06 MDT

87AzRunner posted a photo

Tension clip - IMG_2497.jpg

you can see where it was cut off (about 6 in lower than where its at)

DIY Tie-down bracket

87AzRunner — Sun, 11 May 2008 10:00:51 MDT

87AzRunner posted a photo

DIY Tie-down bracket - IMG_2499.jpg

how-to: take a piece of flat aluminum or steel, drill three holes, two outer for the bolts for the tie down piece and the middle for for factory hard top bolt. slide factory hard top bolt through hole. next bolt tie down piece to flat bar with hard top bolt in place. You're going to need a space between the flat bar and the tie down piece so the hard top bolt fits, just use nuts in between the two. FYI It helps to have the tension strap in place when you put in together because trying to pull the tie-down through the tie-down piece and hardtop bolt is kind of a pain, but it can be done. now it's assembled and you just need a 12mm wrench to bolt it down, and tighten the strap (if the mounting rail is already done) and your good to go.

Another view of DIY Tie-down bracket

87AzRunner — Sun, 11 May 2008 10:00:41 MDT

87AzRunner posted a photo

Another view of DIY Tie-down bracket - IMG_2500.jpg

Top is tight (flappy bad)

87AzRunner — Sun, 11 May 2008 10:00:28 MDT

87AzRunner posted a photo

Top is tight (flappy bad) - IMG_2501.jpg

Bow- Top is tight

87AzRunner — Sun, 11 May 2008 10:00:03 MDT

87AzRunner posted a photo

Bow- Top is tight - IMG_2503.jpg

Fj Top

87AzRunner — Wed, 30 Apr 2008 22:48:43 MDT

87AzRunner posted a photo

Fj Top - 100_1421.jpg

Bracket

87AzRunner — Wed, 30 Apr 2008 22:37:38 MDT

87AzRunner posted a photo

Bracket - IMG_2427.jpg

close-up bracket

87AzRunner — Wed, 30 Apr 2008 22:37:17 MDT

87AzRunner posted a photo

close-up bracket - IMG_2430.jpg

bar in back to keep tension

87AzRunner — Wed, 30 Apr 2008 22:37:00 MDT

87AzRunner posted a photo

bar in back to keep tension - IMG_2431.jpg

back-bracket tie-down

87AzRunner — Wed, 30 Apr 2008 22:36:33 MDT

87AzRunner posted a photo

back-bracket tie-down - IMG_2432.jpg